Sharp AL2021, AL2041 manual → Start printing after quitting all unused application

Problem	Cause and solution	Page
	Simultaneous use of two or more application software
Printing is slow.	programs.	–
	→ Start printing after quitting all unused application
	software programs.
	The paper is loaded so that printing takes place on the
The printed image	rear side of the paper.
is light and	→ Some paper types have a front and rear side. If the	10
uneven.	paper is loaded so that printing takes place on the rear
	side, toner will not adhere well to the paper and a good
	image will not be obtained.
	You are using paper that is outside the specified size
	and weight range.	9
	→ Use copy paper within the specified range.
	Paper curled or damp.
	→ Do not use curled or crimped paper. Replace with dry
	copy paper. During periods when the machine is not	–
	used for a long time, remove the paper from the tray
The printed image
	and store it in a dark place in a bag to prevent moisture
is dirty.	absorption.
	You did not set sufficient margins in the paper settings
	of your application.
	→ The top and bottom of the paper may be dirty if the	–
	margins are set outside of the specified print quality
	area.
	→ Set the margins in the software application within the
	specified print quality area.
	The paper loaded in the tray is not the same size as
	that specified in the printer driver.
	→ Check if the "Paper Size" options suit the size of the	–
	paper loaded in the tray.
	→ If the "Fit To Paper Size" setting is activated, make sure
	that the paper size selected from the drop-down list is
	the same as the size of the loaded paper.
	The orientation of document setting is not correct.
The printed image	→ Click the "Main" tab in the printer driver setup screen,	–
is skewed or it	and verify if the "Image Orientation" option is set to
	your requirements.
runs off the paper.
	Paper is not loaded properly.	10
	→ Make sure the paper is properly loaded.
	You did not correctly specify the margins for the
	application in use.
	→ Check the layout of the document margins and the	–
	paper size settings for the application you are using.		9
	Also check if the print settings are specified correctly to
	suit the paper size.
The printed image	The setting for the print density is not appropriate.
	→ You can adjust the print density on the printer driver.
is darker or lighter		–
	Click the "Advanced" tab in the printer driver setup
than expected.	screen, and click the "Compatibility" button. Select the
	"Print Density Level" from 1 (light) to 5 (dark).

77