Optional Settings

Setting 23: QUICK ON-LINE

When you transmit a multi-page document, this setting determines whether the fax machine will dial the receiving party and begin transmitting while scanning is still in progress, or wait until all pages have been scanned before

dialing. Press 1 to have the fax machine dial and begin transmission while

scanning is still in progress, or 2 to have the fax machine wait until all pages have been scanned.

♦Initial setting: 1

Setting 24: MULTI TTI

If you are using Department Control, you can press 1 to have the

department name (the name associated with the department code entered by an operator to access the fax) appear at the top of each transmitted document. This will appear in place of the name entered in Entering Your

Name and Fax Number in Chapter 1. Press 2 to turn Multi TTI off (the

sender’s name entered in Chapter 1 will appear).

♦Initial setting: 2

Setting 25: BEEP LENGTH

This sets the duration of the beep that signals the end of transmission,

reception, or copying. Press 1 for 3 seconds, 2 for 1 second, or 3 for

no beep.

♦Initial setting: 1

Setting 26: TELEPHONE BILLING CODE

This setting allows you to use Department Codes or direct billing codes for telephone billing on a PBX. (Your dealer must first activate Department

Control or direct billing code entry.) Press 1 to turn telephone billing on, or

2to turn it off.

♦Initial setting: 2

If you pressed

1 , the BILLING CODE DIAL selection will subsequently

appear. Press

1 if your PBX must receive the billing code before dialing a

telephone number, or 2 if it must receive the billing code after dialling a

telephone number. (Refer to your PBX manual or consult your PBX adminstrator for this information.)

6. Optional Settings

113