Sharp R-86STM Your Oven And Accessories, Control panel, Oven lamp, Door opening button, 9 8 7

YOUR OVEN AND ACCESSORIES

10	OVEN:
	1.	Control panel
1	2.	Oven lamp
2	3.	Door opening button
	4.	Waveguide cover (DO NOT REMOVE)
3	5.	Bottom grill heating element
	6.	Turntable motor shaft
9 8 7 6 5 4	7.	Oven cavity

118. Door seals and sealing surfaces

		9. Door latches
		10. Top grill heating element
13		11. Ventilation openings
	12	12. Outer cabinet
		13. Power cord

ACCESSORIES:

Check to make sure the following accessories are provided:

14 14. Turntable	15. High rack
16. Low rack

16 15

NOTES:

•Place the turntable on to the turntable motor shaft, ensuring it is located firmly.

•To avoid turntable damage, ensure dishes or containers are lifted clear of the turntable rim when removing them from the oven.

•For use of the racks, refer to the grill, convection and dual cooking sections on pages 12 to 16.

Never touch the grills when they are hot.

•The waveguide cover is fragile. Care should be taken when cleaning inside the oven to ensure that it is not damaged.

•After cooking fatty foods without a cover, always clean the cavity and especially the grill heating elements thoroughly, these must be dry and free from grease. Built-up grease may overheat and begin to smoke or catch fire.

•Always operate the oven with the turntable fitted correctly. This promotes thorough, even cooking. A badly fitted turntable may rattle, may not rotate properly and could cause damage to the oven.

•The turntable rotates clockwise or anti-clockwise. The rotary direction may change each time you start the oven. This does not affect cooking performance.

•When you order accessories, please quote both the PART NAME and MODEL NUMBER to your dealer or SHARP approved service facility. The model number is located at the bottom of the control panel.

Warning:

The door, outer cabinet, oven cavity, accessories, dishes and especially the grills will become very hot during operation. To prevent burns, always use thick oven gloves.

2

R-86STM_EN.indd 2

2/19/08 4:50:27 PM