Sharp XE-A213 instruction manual Preparing the Cash Register, Initializing the Cash Register

Part1 QUICK START GUIDE Part2 Part3

STEP2 PREPARING THE CASH REGISTER

Unpack the cash register and make sure all accessories are included. For details of accessories, please refer to “SPECIFICATIONS” section on page 95.

For installing the cash register, find a stable surface near an AC outlet where the cash register will not subject to water sources or direct sunlight.

For preparing the cash register, please follow the three steps shown below; "1 Initializing the Cash Register" on page 9, "2 Installing Batteries" on page 10, and "3 Installing a Paper Roll" on page 11.

1

Initializing the Cash Register

In order to operate the cash register properly, you must initialize it before operating for the first time. Follow this procedure.

1.Insert the manager (MA) key into the mode switch and turn it to the REG position.

2.Insert the plug of the AC power cord into the AC outlet. The buzzer will sound three times.

IMPORTANT: This operation must be performed without batteries installed.

REG

OPX/Z MGR

X1/Z1

X2/Z2

PGM

3.The cash register has now been initialized. The register display will show "0.00" and then “NO BATTERY”.

NO BATTERY

If the buzzer does not sound when the plug is inserted, the initialization has not been done successfully. (This will occur when the voltage is high because you operated the cash register before starting initialization.) Wait at least one minute after pulling out the plug and insert the plug again.

9