Sharp XE-A213 Removing a Paper Jam, Cleaning the Printer Print Head / Sensor / Roller

7.Insert the end of the paper into the slit in the spool. (Press the F

key to feed more paper if required.)

8. Wind the paper two or three turns around the spool shaft.

9. Set the spool on the bearing, and press the Fkey to take up excess slack in the paper.

10. Replace the printer cover.

You can wind the roll paper in OP X/Z, X1/Z1, and X2/Z2 modes even if you programmed so that the printer is used for issuance of receipts. This may be convenient to wind reports. In this case, set the roll paper to the take-up spool.

6Removing a Paper Jam

Caution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself. Never touch the print head immediately after printing, as the head may still be hot.

1.Remove the printer cover.

2.Lift up the print roller release lever to unlock and open the print roller arm.

3.Remove the paper jam. Check for and remove any shreds of paper that may remain in the printer.

4.Reset the paper roll correctly by following the steps in “Installing the paper roll”.

7Cleaning the Printer (Print Head / Sensor / Roller)

When the printed text is getting dark or faint, paper dust may be stuck to the print head, sensor and/or roller. Clean them as follows:

Caution:

•Never touch the print head with a tool or anything hard as it may damage the head.

•The paper cutter is mounted on the printer cover. Be careful not to cut yourself.

	Print head	1.	Turn the mode switch to the “ ” position.
		2.	Remove the printer cover.
		3.	Lift up the print roller release lever to unlock and open the
		4.	print roller arm.
			Remove the paper roll referring to the “Removing the
		5.	paper roll” section.
			Clean the print head with a cotton swab or soft rag
			moistened with ethyl alcohol or isopropyl alcohol. Clean
			the roller and the sensor in the same manner.
Roller	Sensor	6. Reset the paper roll correctly by following the steps in
			“Installing the paper roll”.

92