Sharp XE-A213 instruction manual Installing the paper roll, Installing the receipt paper roll

Part1 Part2 Part3 FOR THE MANAGER

Installing the paper roll

Caution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.

Installing the receipt paper roll:

Paper positioning guides

1.Turn the mode switch to a position other than “ ” with the power cord connected.

2.Remove the printer cover.

3.Lift up the print roller release lever to unlock and open the print roller arm.

4.Set the paper correctly in the paper roll cradle.

5.Feed the end of the paper along with the paper positioning guides.

Installing the journal paper roll:

6.While holding down the paper, slowly close the print roller arm, and push down the arm until you hear a click locking the arm. Make sure securely you push down the center of the wing part of the arm as per the diagram. The paper will be fed automatically.

If the print roller arm is not securely locked, printing is not done right. If this problem occurs, open the arm, and close the arm as instructed above.

7.Cut off the excess paper using the edge of the inner cover, and replace the printer cover. Press the Fkey to make sure the paper end comes out of the printer cover and clean paper appears.

If the paper end does not come out, open the printer cover, and pass the paper end between the paper cutter and the paper guide of the printer cover, and replace the cover.

1.Turn the mode switch to a position other than “ ” with the power cord connected.

2.Remove the printer cover.

3.Lift up the print roller release lever to unlock and open the print roller arm.

4.Set the paper correctly in the paper roll cradle.

5.Feed the end of the paper along with the paper positioning guides.

6.While holding down the paper, slowly close the print roller arm, and push down the arm until you hear a click locking the arm. Make sure securely you push down the center of the wing part of the arm as per the diagram. The paper will be fed automatically.

If the print roller arm is not securely locked, printing is not done right. If this problem occurs, open the arm, and close the arm as instructed above.

91