AT Command Set
MC35_ATC_01_V05.00 Page 102 of 256 15.07.2002
turns to the AT command mode.
3. There are various options to switch from data mode to command m ode:
a) Escape sequence +++
b) Circuit 108/2 (DTR) changes from ON to OFF, reaction depends on
command at&d (caution if AT&D0: TA ignores status on DTR).
c) The message Modem Status Command (MSC) for control chann el is
defined by the multiplexer protocol GSM07.10. MSC conveys V.24
signals. Bit 3 of Control Signal Octet is DTR, reaction depends on
command at&d (caution if AT&D0: TA ignores status on DTR).
4. The parameter maximum frame size (N1) of AT+CMUX in GSM07.07 is
fixed to 97 and cannot be changed. All other parameters are not avail-
able.
5. Multiplex mode can be terminated by AT^ SMSO (,AT^SMSO Switch off
mobile station" pg. 202). It has to be reestablished after power-o n.
4.28.1 Restricted use of AT commands in Multiplex mode
In Multiplex mode, the operation of several AT commands varies f rom the normal mode. This chapter
summarizes the concerned commands. For general rules and restrictions to be considered in Mu ltiplex
mode please refer to [5].
Data, fax and GPRS calls can only be set up on logical channel 1. Due to this restriction, AT com-
mands have a different behaviour on channels 2+3 compared to channel 1. Several comm ands are
not available, others return different responses. These commands are lis ted in the table below:
Table 8: Availability of AT commands on virtual channels
Command Behaviour on channel 1 Differences on channel 2+3
+++ as described3) no data calls
ATE as described as described
AT+CBST as described not usable
AT+CR as described not usable
AT+CRLP as described not usable
AT+CG... (GPRS commands) as described usage not recommended 2)
AT+F.... (Fax commands) as described not usable
AT&C as described not usable
AT&D as described not usable
AT&F as described data call parameters not changed,
S3, S4 not changed
AT&S as described not usable
AT&V as described data call parameters not displayed
ATA as described no data calls
ATD as described no data calls
ATDI<n> as described not usable
ATO as described not usable
ATS0 1) as described not usable
ATS3 1) as described as described
ATS4 1) as described as described
ATS5 1) as described not usable
ATS6 1) as described not usable
ATS7 1) as described not usable