Assembly

en

 

Mount the Grass Bag

CHARGE THE BATTERY

1.Mount the grass bag assembly onto the rear bagger brackets as shown (see Figure 5).

a.Use one hand to grab onto the handle at the rear of the bag frame assembly.

WARNING

When you charge the battery, do not smoke. Keep the battery away from any sparks. The fumes from the battery acid can cause an

b. Use the other hand to hold the top bagger

 

explosion.

handle and guide the bag frame assembly

 

1.

To disconnect the battery retainer (4), push in on

onto the rear bagger brackets.

 

 

2. When mounting the bagger frame assembly, hold

 

the lower end of the battery retainer (see Figure 6).

2.

Remove the battery (3) from the opening between

the bottom of the grass bagger assembly slightly

away from the rear plate.

 

 

 

 

the engine and the seat support.

3. Rotate the grass bagger assembly until it locks

 

3.

Remove the protective cap from the

in place.

 

 

 

4.

battery terminals.

Maintenance Free Battery

 

 

Use a 12 volt battery charger to charge the battery.

 

 

 

Charge at a rate of 6 amps for one hour. If you do

IMPORTANT: Before you attach the battery cables to

 

not have a battery charger, have an authorized

 

service center charge the battery.

the battery, check the battery date. The battery date

 

tells if the battery must be charged.

Reproduction

 

 

 

5.

Install the battery. Make sure the positive (+)

1. Raise the seat support (see Figure 2).

 

 

 

te minal is on the right side.

2. Remove two screws (1) and battery cover (2)

 

6.

Connect the battery retai er.

(see Figure 6).

Not

INSTALL THE BATTERY CABLES

the battery date.

 

 

for

WARNING

3. Check the side of the battery (3) for the loca ion of

 

 

 

a. If the battery is put into service bef

re this

 

To prevent sparks, fasten the red cable to the

date, the battery cables can be attached

 

positive (+) terminal before you connect the

without charging the battery. See “Install the

negative (-) black cable.

Battery Cables.”

 

 

 

1.

Remove the protective caps from the battery

b. If the battery is put into service after this date,

 

terminals (see Figure 6).

the battery must be charged. See “Cha ge

 

2.

Slide the terminal boot (5) onto the red cable (6).

the Battery.”

 

 

 

 

 

 

3.

Connect the red cable to the positive (+) terminal

 

 

 

 

 

with the fasteners (7).

 

 

 

 

4.

Connect the black cable (8) to the negative (-)

 

 

 

 

 

terminal with the fasteners (7).

 

 

 

 

5.

Install the battery cover (2) with the two screws (1).

15