en
Remove the Battery |
|
|
|
| 4. Connect the red cable (6) to the positive (+) | ||||||||
To charge or clean the battery, remove the battery from |
| terminal using the fasteners (7). |
| ||||||||||
| WARNING |
| |||||||||||
the unit as follows. |
|
|
|
|
|
| |||||||
WARNING |
|
|
|
| To prevent sparks, fasten the red cable to the | ||||||||
To prevent sparks, fasten the red cable to the |
| positive (+) terminal before you connect the | |||||||||||
| negative |
|
|
| |||||||||
positive (+) terminal before you connect the |
| 5. Connect the black cable (8) to the negative | |||||||||||
negative |
|
|
|
| |||||||||
WARNING |
|
|
|
|
| terminal with the fasteners (7). |
| ||||||
|
|
|
| 6. | Connect the battery retainer (4). |
| |||||||
| The battery contains sulphuric acid which is |
| 7. | Install the battery cover (2) using two screws (1). | ||||||||||
| harmful to the skin, eyes and clothing. If the |
| Adjust the Gauge Wheels |
| ||||||||||
| acid gets on the body or clothing, wash |
|
|
| ||||||||||
| with water. |
|
|
|
| IMPORTANT: Before you adjust the gauge wheels, you | ||||||||
1. Remove the two screws (1) and battery cover (2) | must do the following. Make sure the mower deck is | ||||||||||||
level. Make sure the height of cut is set at the height | |||||||||||||
(see Figure 6). |
|
|
|
| you want for your lawn. Mow a short distance on a flat | ||||||||
2. Disconnect the black cable (8) from the negative ( - | level area and look at the area that was cut. If the | ||||||||||||
) terminal. |
|
|
|
| mower deck does ot cut level, see an |
| |||||||
3. Disconnect the red cable (6) from the positive |
|
| autho ized dealer. | lt (2), sleeve (3), and gauge | |||||||||
( + ) terminal. |
|
|
|
| 1. Remove he nut (1), b | ||||||||
4. To disconnect the battery retainer (4), push in on |
| wheel (4) fr | m he m | wer deck bracket. |
| ||||||||
the lower end of the battery retainer. |
| for2. Pla e lift lever in the desired height of cut setting | |||||||||||
5. Remove the battery (3) from the opening be ween |
| (see Fig re 15). |
|
|
|
|
| ||||||
the engine and the seat support. |
|
|
| 3. Mow a short distance on a flat area to check the | |||||||||
Charge the Battery |
|
|
|
|
| level of cut. |
|
|
|
|
|
| |
|
|
|
| 4. Assemble gauge wheels in the hole on the gauge | |||||||||
1. Before you charge the battery (3), remove the |
|
|
| wheel bracket that positions the gauge wheel | |||||||||
battery (see Figure 6). |
| Not |
|
| closest to the ground without touching the ground | ||||||||
2. To charge the battery, use a 12 volt battery cha ger. |
| (see Figure 20 and Table below). |
| ||||||||||
Charge at a rate of 6 amps for 1 hour. If you do not | Front Wheel (A, Fig. 20) |
| Rear Wheel (B, Fig. 20) | ||||||||||
have a battery charger, have an authoriz d d | aler |
|
|
|
|
|
|
|
|
| |||
Bracket Hole |
| Lift Lever |
|
| Bracket Hole |
| Lift Lever | ||||||
charge the battery. |
|
|
|
|
|
|
|
| |||||
3. Install the battery. |
|
|
|
|
| Number |
| Position |
|
| Number |
| Position |
|
|
|
|
| 1 |
| 1,2,3 |
|
| 1 |
| 1 | |
|
|
|
|
|
|
|
|
|
| ||||
WARNING | Reproduction |
|
|
|
| ||||||||
| 2 4,5,6 |
| 2 |
| 2 | ||||||||
| When you charge the battery, do not smoke. |
|
|
|
|
|
|
| 3 |
| 4,5,6 | |||
Keep the battery away from any sparks. The |
|
|
|
|
|
|
|
|
|
|
| ||
|
| 5. Secure the gauge wheel (4), sleeve (3), and bolt (2) | |||||||||||
| fumes from the battery acid can cause |
|
| |||||||||||
| an explosion. |
|
|
|
|
| on bracket with nut (1). |
|
|
| ||||
24