Adjustingthe image
Referto these notes when adjusting the projectedimage as describedin the included SMART Board
480ivand 680ivInteractive WhiteboardSys tems InstallationGuide (smarttech.com/kb/153153).
lProjecta computer images et to the properresolutionw hileadjusting the image. If you don’t
havea computer, use the projector’sdefault backgroundso that you can see the full projected
imageclearly. If possible, use a pure white screen to allow for easier alignment.
lUset hemechanical adjustments describedin the installation document to make image
adjustmentsinstead of the projector’s on-screenmenuoptions.
lDon’tloosen the knob andlock ings crew too much orthe projector won’t hold the adjustments.
lAs you tilt the projectorup or lower its mounting boomto raise the image, the entire projected
imageincreases ordecreases in size, especially at thebottom of the projected image.
lWhenadjusting keystone (tilt), ensuret hatt het opand bottom edges of the imageare
horizontalbeforeyou position the left and right edgesof t heimage relative to your interactive
whiteboard.
lWhenyou move the projectorforward or backward ont heboom to make the image largeror
smaller,you might need to tilt or turn the projectorslightly t o keepthe image square.
lTofine-tune the image,you may need to repeat all steps describedin the installation document
insmaller increments.
SMARTV25 projectorconnection diagram
Youcan connect a variety of peripheraldevices to your projector, includingDVD /Blu-rayplayers,
VCRs, documentcameras, digital camerasand high-definitionsources, asw ellas peripheraldevice
outputs,such as a s econdaryprojectoror a flat-panel display andpowered speakers.
NN O T E
Youmight need to purchasethird-party adaptersto connect certain peripheraldevices.
CH A P T E R 3
Usingyour interactivew hiteboard system
18