Thesecommands informy ouof thecurrent audiooutput settings.
Command Response
getvolume volume=[currentvolumes etting]
getmute mute=[currentmute setting]
getvolumecontrol volumecontrol=[currentvolumecontrol setting]
getcc cc=[currentclosed captioning languagesetting]
Thesecommands controly ouraudio output settings. See Value-basedcommandmethods on page
56for setting absolute andadjustment commands.
Command Command targetrange Response
setv olume[value] =0to =40 volume=[value]
setmute [t arget] =on
=off
mute=[target]
setv olumecontrol[target] =on
=off
volumecontrol=[target]
setc c [target] =cc1
=cc2
=off
cc=[target]
NN O T E
Typically, cc1 displays American Englishs ubtitles, while cc2 displays other regionallanguages,
suchas French or Spanish, dependingont elevisionc hannelor medias etup.
Networkcontrols
Thesecommands controly ourprojector’s network status and settings. These settings are available
evenwhen the projectoris inStandby mode. You must locally set the network and VGA out
commandsto on, which is located in the OSD f orthe network abilities to work.
Thesecommands informy ouof thecurrent network settings.
Command Response
getnetstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
getdhcp dhcp=[currentDHCP s tatus]
getipaddr ipaddr=[currentIP address]
getsubnetmask subnetmask=[currentsubnetw orkmask number]
getgateway gateway=[currentnetwork gateway]
getprimarydns primarydns=[currentprimarydomain namenumber]
getmacaddr macaddr=[currentMAC address]
AP P E N D I X A
Remotelymanaging your intera ctivewhiteboar d system
62