5. Replacethe boom endcap.
6. Connectthe cables to the projector.
7. Connectthe power cable to a poweroutlet.
8. Pressthe Power button onceon the remote control to confirm that the projectoris operating
andthat the lamp moduleis correctlyinstalled, and then wait for the projectorto t urnon
completely.
9. Wait five minutes for the projectorto warm up.
NN O T E
Youmight need to adjust the projectedimage after you performthe previous procedures.For
moreinformation,s eethe included SMART Board 480iv and 680ivInteractive Whiteboard
Systems Installation Guide(smarttech.com/kb/153153)and Adjusting the imageon page 18.
Resettingthe lamp timer
Afteryou replace the lamp, you needto access theprojector service menuand reset the lamp hour
counter.To preventacc identalerrors, only a system administrator shouldperform this procedure.
NN O T E
Always reset the LampHours after you replace thelamp because lamp service remindersare
basedon the currenthours of use.
CH A P T E R 5
Maintainingyour interactivew hiteboard system
33