SMC Networks SMCWBR11S-3GN manual Mounting the Device, Mounting on a Horizontal Surface

CHAPTER 3 Installing the Mini 3G Router

Mounting the Device

MOUNTING THE DEVICE

The Mini 3G Broadband Router can be mounted on any horizontal surface, or on a wall. The following sections describe the mounting options.

MOUNTING ON A WALL The Mini 3G Broadband Router should be mounted only to a wall or wood surface that is at least 1/2-inch plywood or its equivalent. To mount the unit on a wall, always use its wall-mounting slots.

Figure 9: Wall Mounting

Mounting Slots

MOUNTING ON A HORIZONTAL SURFACE

To mount on a wall, follow the instructions below.

1.Mark the position of the two screw holes on the wall. For concrete or brick walls, you will need to drill holes and insert wall plugs for the screws.

2.Insert two 20-mm M4 tap screws (not included) into the holes, leaving about 2~3 mm (0.08~0.12 inches) clearance from the wall.

3.Line up the two mounting points on the unit with the screws in the wall, then slide the unit down onto the screws until it is in a secured position.

To keep the Mini 3G Broadband Router from sliding on the surface, the unit has four rubber feet on its base.

It is recommended to select an uncluttered area on a sturdy surface, such as a desktop or table. The unit can also be protected by securing all attached cables to a table leg or other nearby fixed structure.

– 30 –