
2 Power on the hard disk.
Caution
Always connect the hard disk and power it on before starting up this unit.
3 Press the 1 (power) button on the side panel, to start up this unit.
The operation screen appears, and the device status for the source viewer for the interface module to which the hard disk is connected shows the hard disk number, remaining capacity, and available recording time.
Remaining capacity
Available recording time
Hard disk number
Caution
When recording two sources simultaneously, the indicated remaining capacity diminishes at twice the normal rate, and therefore the actual remaining recording time is approximately half of that shown.
Starting recording for each input1 Select the source to be recorded in the NEXT selection buttons.
Caution
The inputs that can be recorded are only those to the external interface module to which the hard disk is connected (inputs for which the source viewer shows the hard disk number and recording status).
2 Hold down the REC button and press the PLAY button.
| |
PLAY button | REC button |
| REC |
| SHIFT |
The source viewer device status shows “REC PAUSE”.
The following confirmation message also appears at the same time.
Operations 3 Chapter
Recording Video and Audio on an External Device | 145 |
| |
|
|