Recording tips (continued)

Marking track numbers

• Automatically during recording

Track numbers are automatically marked as on the original source during recording from this system’s CD player or components connected to the DIGITAL OPTICAL IN jack. However, track numbers may not be marked for some tracks (see page 56). Use the Level Synchro Recording function to automatically mark track numbers during recording from this system’s tuner or components connected to the TAPE IN jack.

• At any point during recording

You can mark track numbers during manual recording of any source (see page 25).

• After recording

Use the Divide Function (see page 37).

Marking track numbers automatically during recording

— Level-Synchro Recording

The Level-Synchro Recording function is factory-set to on, so the track numbers are automatically marked. If “L-SYNC” does not appear during recording, turn on the Level- Synchro Recording as follows. Track numbers are automatically marked when the input signal is continuously below a certain level for more than 2 seconds and then exceeds that level.

Note

You cannot mark track numbers automatically if the sound source to be recorded is noisy (e.g., tapes or radio programs).

1Press FUNCTION repeatedly until “MD” appears in the display.

2Press MENU/NO on the remote.

3Press . or > repeatedly until “Setup?” appears in the display, and then press ENTER/YES on the remote.

4Press . or > repeatedly until “T.Mark Off” (or “T.Mark LSync”) appears, and then press ENTER/YES on the remote.

5Press . or > repeatedly to select the setting, and then press ENTER/YES on the remote.

To

Select

Turn on the Level Synchro

T.Mark LSync

Recording function

(factory setting)

 

 

Turn off the Level Synchro

T.Mark Off

Recording function

 

 

 

When you set the Level Synchro Recording function, “L-SYNC” lights up.

6Press MENU/NO on the remote.

To continue and record, follow the procedures described on the various recording pages.

24