Setting the time
1
2 Press CLOCK/TIMER SET on the remote.
If you are setting the clock for the first time, go to step 5.
3 Press – or + (.or >) on the remote repeatedly until “CLOCK SET?” appears in the display.
4 Press ENTER/YES on the remote.
The day indication flashes.
5 Press – or + (.or >) on the remote repeatedly to set the day, and then press ENTER/YES or CURSORt on the remote.
The hour indication flashes.
6 Press – or + (.or >) on the remote to set the hour, and then press ENTER/YES or CURSORt on the remote.
The minute indication flashes.
7 Press – or + (.or >) on the remote repeatedly to set the minute, and then press ENTER/YES on the remote.
If you made a mistake
Press TCURSOR or CURSORton the remote until the indication you wish to change (day, hour, minute) flashes, and then change the setting.
To reset the time
Start over from step 1.
Conserving power in
standby mode
Even if the system is off, the unit consumes power to power the clock and to stay responsive to commands from the remote. Power saving mode was introduced to reduce the amount of power consumed during standby.
In this mode, the clock or demonstration is not displayed.
To change to power saving mode, press DISPLAY or TIME on the remote repeatedly while the system is off until demonstration mode and the clock disappear from the display.
To change the display
Press DISPLAY or TIME on the remote repeatedly while the system is off.
The display changes as follows:
Clock display* tDemonstration mode** t Power saving mode t Clock display* t…
*After about 8 seconds, the system returns to power saving mode.
**The indications in the display and lamps on several buttons light up or flash even after the system is turned off.
Tip
The timer continues to operate during power saving mode.
8