Tuner

Presetting radio stations

The system can store a total of 30 preset stations (20 for FM and 10 for AM).

1 Press FUNCTION (or TUNER BAND on the remote) repeatedly to select FM or AM.

2 Press TUNING MODE on the remote repeatedly until “AUTO” appears in the display.

3 Press TUNING + or –.

The frequency changes as the system scans for a station. Scanning stops automatically when a station is tuned in. At that time, “TUNED” and “STEREO” (for stereo program only) appear.

4 Press MENU/NO on the remote.

5 Press TUNING + or – repeatedly until “Memory?” appears, and then press ENTER/YES on the remote.

A preset number appears in the display. Perform steps 6 and 7 while the preset number is flashing.

6 Press TUNING + or – repeatedly to select the desired preset number.

7 Press ENTER/YES on the remote.

“Complete!” appears, and then the station is stored.

8 Repeat steps 1 through 7 to preset other stations.

To cancel presetting

Press MENU/NO on the remote during steps 5 and 6.

To tune in a weak station

In step 2, press TUNING MODE on the remote repeatedly until “MANUAL” appears in the display, then press TUNING + or – repeatedly to tune in the station.

To change the preset number

Start over from step 1.

To change the AM tuning interval (not applicable on the European model)

The AM tuning interval is factory-preset to 9 kHz (or 10 kHz for some areas). To switch the AM tuning interval, tune in any AM station first, then turn off the system. Pressing and holding down FUNCTION turn the system back on. When you change the interval, all the AM preset stations are erased. To change back to the original interval, repeat the same procedure.

Tip

The preset stations are saved in the system’s memory for about a day even if you disconnect the power cord or a power failure occurs.

42