Labeling an MD (continued)
After recording
Use the Name function on this page. You can enter a total of approximately 1,700 characters for the disc title, track titles and group titles on a single MD. Do the procedure below with the Group function on. To label a group, see “Labeling a group” on page 31.
Be sure to press GROUP ON/OFF so that the Group function is on before you label an MD recorded with the Group function so as not to overwrite the group information on the MD.
For details, see page 27.
1 Press FUNCTION on the remote repeatedly until “MD” appears in the display.
To label a track, press .or > repeatedly until the desired track number appears.
2 Press NAME EDIT/SELECT on the remote.
The cursor starts flashing.
3 Press NAME EDIT/SELECT on the remote repeatedly to select the desired type of character.
The display changes as follows: Selected AB* (Upper cases) t Selected ab* (Lower cases) t Selected 12 (Numbers) t Selected AB* (Upper cases)
t…
*Press number 1 repeatedly to display the following symbols.
‘
In addition, when the symbols above appear in the display, press .or >repeatedly to display the following symbols.
& + < > _ = ” ; # $ % @ 
`
4 Enter a character.
If you have selected uppercase or lowercase letters
1Press the corresponding letter button on the remote repeatedly until the character to be entered flashes.
Or, press the button once and press . or >repeatedly.
2Press CURSORt on the remote.
The flashing character is entered and the cursor shifts to the right.
If you have selected numbers
Press the corresponding number button on the remote.
The number is entered and the cursor shifts to the right.
To enter a blank space
1Press NAME EDIT/SELECT on the remote to select upper case or lower case letters.
2Press 10/0 on the remote.
A blank space is entered and the cursor shifts to the right.
5 Repeat steps 3 and 4 to enter the rest of the name.
To change a character
Press TCURSOR or CURSORt on the remote repeatedly until the character to be changed flashes, press CLEAR on the remote to erase the character, then repeat steps 3 and 4.
6 Press ENTER/YES on the remote to complete the labeling procedure.
The titles you labeled appear sequentially, and then the original display appears.
Note
You can label a track title during play. The play repeats until you finish labeling.
30