Tips
•The “LARGE” and “SMALL” settings for each speaker determine whether the internal sound processor will cut the bass signal from that channel.
When the bass is cut from a channel, the bass redirection circuitry sends the corresponding bass frequencies to the subwoofer or other “LARGE” speakers.
However, since bass sound has a certain amount of directionality, it is best not to cut it, if possible. Therefore, even when using small speakers, you can set them to “LARGE” if you want to output the bass frequencies from that speaker. On the other hand, if you are using a large speaker, but prefer not to have bass frequencies output from that speaker, set it to “SMALL.”
If the overall sound level is lower than you prefer, set all speakers to “LARGE.” If there is not enough bass, you can use the equalizer to boost the bass levels.
•The surround back speakers will be set to the same setting as that of the surround speakers.
•When the front speakers are set to “SMALL,” the center, surround, and surround back speakers are also automatically set to “SMALL.”
•If you do not use the subwoofer, the front speakers are automatically set to “LARGE.”
Crossover Freq (Speaker crossover frequency)
Lets you set the bass crossover frequency of speakers that has been set to “SMALL” in the Speaker menu. Measured speaker crossover frequency is set for each speaker after the auto calibration.
1 Press B/b to select the speaker on the screen you want to adjust.
2 Press V/v to adjust the value, then press b.
You can select the test tone type on the Test Tone screen.
Tips
•To adjust the level of all speakers at the same time, press MASTER VOL
•The adjusted value is shown on the display during adjustment.
To output a test tone from each speaker
You can output a test tone from the speakers in sequence.
1Press B/b to select “Test Tone,” then press 
.
The Test Tone screen appears.
2Press V/v to adjust the parameter, then press 
.
•OFF
•AUTO
The test tone is output from each speaker in sequence.
•L, C, R, SR, SBR, SBL, SL, SW
You can select which speakers will output the test tone.
3Press V/v to adjust “Level:,” then press
.
To output a test tone from adjacent speakers
You can output a test tone from adjacent speakers so that you can adjust the balance between the speakers.
1Press B/b to select “Phase Noise,” then press 
.
The Phase Noise screen appears.
2Press V/v to adjust the parameter, then press 
.
•OFF
•L/R, L/C, C/R, R/SL, R/SR, SR/SL, SR/ SBR, SBR/SBL, SR/SB, SBL/SL, SB/ SL, SL/L, L/SR
Lets you output the test tone sequentially
116GB