Selecting the front speakers

You can select the front speakers you want to drive.

SPEAKERS switch

Set the SPEAKERS switch to select the front speaker system you want to drive.

Note

This setting is not available when headphones are connected.

Set to To select

AThe speakers connected to the FRONT SPEAKERS A terminals.

BThe speakers connected to the FRONT SPEAKERS B terminals.

A+B

The speakers connected to both the

 

FRONT SPEAKERS A and B

 

terminals (parallel connection).

 

 

OFF

No audio signals are output from

 

any speaker terminals, or the PRE

 

OUT jacks.

 

 

9:Calibrating the appropriate speaker settings automatically(Auto Calibration)

The DCAC (Digital Cinema Auto Calibration) function allows you to perform automatic calibration, such as checking the connection between each speaker and the receiver, adjusting the speaker level, and measuring the distance of each speaker from your seating position automatically.

Before you perform the auto calibration

Before you perform the auto calibration, set up and connect the speakers (page 22-25).

•The AUTO CAL MIC jack is used for the supplied optimizer microphone only. Do not connect other microphones. Doing so may damage the receiver and the microphone.

•During the measurement, the sound that comes out of the speakers is very loud. The volume of the sound cannot be adjusted. Pay attention to the presence of children or to the effect on your neighborhood.

•Perform the measurement in a quiet environment to avoid the effect of noise and get a more accurate measurement.

•If there are any obstacles in the path between the optimizer microphone and the speakers, the calibration cannot be performed correctly. Remove any obstacle from the measurement area to avoid measurement error.

•When you use a bi-amplifier connection, set “Sur Back Assign” to “BI-AMP” in the Speaker settings menu before you perform auto calibration.

Notes

•The auto calibration function does not work if headphones are connected.

•Cancel MUTING if it is set to on.

48GB