The image of the COMPONENT VIDEO OUT is corrupted.

•Video input signals other than 480p component are not received when signals are output from the VIDEO jack. Input 480i component video signals.

•When component input signals other than 480p are output, use the COMPONENT VIDEO OUT jack and set “Resolution” to “DIRECT.”

Images from the component connected to the HDMI jack are not output to the TV, are distorted, or are interrupted.

•Make sure that cables are correctly and securely connected to components.

•Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.

•Be sure to use a connecting cable for the HDMI jack corresponding to high speed (an HDMI version1.3a, category 2 cable) when you view images or listen to sound during a Deep Color transmission.

•Images from the component connected to the HDMI jack may be distorted. In this case, set “Video Direct” to “ON” in the HDMI settings menu.

•Images or sound from the component connected to the HDMI jack may be interrupted when video signals are switched. In this case, set “Video Direct” to “ON” in the HDMI settings menu.

Recording cannot be carried out.

•Check that the components are connected correctly (page 33).

•Select the source component (page 58).

The GUI does not appear on the TV screen.

•Press GUI MODE to display “GUI MODE” on the display.

•Check the TV is connected correctly.

Images appear later than the associated sound is played when the HDMI input is selected.

•Depending on the component connected to the HDMI jack, or the source played back, images may appear later than the associated sound. In this case, set “Video Direct” to “ON” in the HDMI settings menu.

Tuner

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown on page 168. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe.

Outdoor FM antenna (aerial)

Receiver

Ground (earth) wire (not supplied)

To ground

Radio stations cannot be tuned in.

•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.

•Keep the satellite radio antenna, away from the speaker cords and the power cord to avoid picking up noise.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

168GB