Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 67).

Press DISPLAY so that the frequency appears on the display.

The system cannot receive satellite channels at all.

The receiving condition is not good. Move the antenna to the place where the condition is good.

Check that you subscribed to the desired satellite radio service (see page 68).

Control for HDMI

The Control for HDMI function does not work.

Check the HDMI connection (page 34).

Make sure “Control for HDMI” is set to “ON” in HDMI settings menu.

Make sure the connected component is compatible with the Control for HDMI function.

Check the Control for HDMI settings on the connected component. See the operating instructions of the connected component.

If you change the HDMI connection, connect/disconnect the AC power cord, or there is a power failure, repeat the procedures of “Preparing for the “BRAVIA” Sync” (page 98).

If you select HDMI B using the HDMI OUTPUT button, after you have selected HDMI A, the Control for HDMI function may not work properly for a while. This is because the component connected to the HDMI A jack must re-recognize the receiver that is equipped with the Control for HDMI function. If the Control for HDMI function does not work properly for a long time, perform the steps given in

“Preparing for the “BRAVIA” Sync” (page 98).

When HDMI B is selected, the Control for HDMI function does not work.

No sound is output from the receiver and TV speaker while using the System Audio Control function.

Make sure the TV is compatible with the System Audio Control function.

If the TV does not have System Audio Control function, set the “Audio Out” settings in HDMI settings menu to

“TV+AMP” if you want to listen to the sound from the TV speaker and receiver.

“AMP” if you want to listen to the sound from the receiver.

You cannot listen to the sound of a component connected to the receiver while a TV is selected as the input on the receiver.

Change the input of the receiver to HDMI when you want to watch a program on a component connected to the receiver.

Change the TV channel when you want to watch a TV broadcast.

Select the component or input you want to watch when you watch a program on the component connected to the TV.

Refer to the operating instructions of the TV on this operation.

When using the Control for HDMI function, you cannot control the connected component using TV’s remote.

Depending on the connected component and TV, you may need to set up the component and TV. Refer to the operation instructions supplied with each component and TV.

Change the input of the receiver to the HDMI input connected to the component.

Information Additional

169GB