6
7
8
9
Press V/v repeatedly to select the component you want, then press 
.
Press V/v repeatedly to select “Learn Mode,” then press 
.
Press V/v repeatedly to select the code number you want to store as the new command, then press 
.
Keep pressing the corresponding button on the remote of the component to be programmed while pointing the remote towards the receiver’s remote sensor until “Complete” is displayed on the TV screen.
Remote sensor
About 5 cm - 10 cm (2" - 4")
To cancel learning
Select “Cancel” on one of the screens displayed in step 8, 10 and 11, then press 
.
To use a command that has been learned
1Press AMP.
The receiver can be operated using the remote.
2Press MENU.
The menu is displayed on the TV screen.
3Press V/v repeatedly to select “Input,”
then press 
or b.
4Press V/v repeatedly to select the component you want, then press 
.
5Press QUICK CLICK.
6Press V/v/B/b to select the button on
the 
.
“Test” is selected automatically after few seconds when the registration of a new code is completed.
10Press 
.
The operation test of the programmed code is started.
Proceed to step 11 if you will not perform the operation test.
11Press V/v/B/b repeatedly to select “Finish.”
Note
The display window is turned off while the receiver is registering the new code.
Click) (Quick Remote
159GB