Setting remote commander codes that are not stored in the remote
Even if a remote commander code is not one of the presets stored in the remote, it is possible for the remote to learn the code using the learning function.
Note
When setting up the receiver to learn the remote command modes, replace the batteries with new ones.
THEATER | RM SET |
| UP |
SHIFT |
|
Numeric buttons
Input buttons
Example for storing a new commander code for the numeric button 1 when the VIDEO2 input is selected.
1 Press THEATER while pressing
RM SET UP.
The RM SET UP button lights up.
2 Press the input button (VIDEO2 in the example) for the component you want to operate with the new command.
The input button flashes. (The RM SET UP button remains lit.)
3 Press SHIFT, then press the numeric buttons (button 1 in the example) you want to store the new command.
The input button you selected in step 2 lights up. (The RM SET UP button remains lit.)
4 Point the remote code receiver section of the remote toward the receiver/transmitter on the remote commander to be learned from.
While the second remote is receiving the signal, the input button selected in step 2 turns off.
About 5 cm - 10 cm (2" - 4")
The RM SET UP button flashes twice, then the learning process is completed. When the learning process fails, the RM SET UP button flashes five times. Try to perform process again from step 2.
5 Press RM SET UP to finish the | Using | |
Learning function process. | ||
| ||
Tips | the | |
• When the memory capacity for storing remote | ||
Remote | ||
commander codes reaches a certain limit, the RM | ||
| ||
SET UP button flashes 10 times, and then the |
| |
learning process ends. |
| |
• If the RM SET UP button flashes five times in step |
| |
1, and the learning process does not start, replace |
| |
the batteries with new ones. |
| |
To cancel learning |
| |
Press RM SET UP. Also, not pressing any |
| |
button for 60 seconds cancels the settings. |
|
143GB