Use the following procedure.

1 In the pattern/numeric keypad, press the DIRECT RECALL button, turning it on.

This switches to direct recall mode.

2 Press the one of buttons 0 to 9 corresponding to the snapshot you want to recall.

This recalls the snapshot.

To cancel the snapshot recall operation

In step 4, press the LEARN button instead of the ENTER button. The

LEARN button goes out and the operation is canceled.

Returning to the previous image with the LAST X function To return to the state before recalling a snapshot, use the following procedure.

1 Press the RECALL button in the snapshot section, turning it on. Alternatively, press the DIRECT RECALL button, turning it on.

2 Hold down the ENTER button in the pattern/numeric keypad, and press the LAST X button.

Snapshot Demonstration

You can automatically show all of snapshots 0 to 99 in sequence.

You can use this function for checking the snapshots, and also in the same manner as the factory setting demonstration (see page 3-8).

The snapshot registers and factory setting demonstration registers are separate. Even after changing the settings in the snapshot registers, you can still run the factory setting demonstration unchanged.

To start the demonstration

Hold down buttons 1 and 9 in the pattern/numeric keypad, and press the AUTO TRANS button in the effect transition section.

This plays back the snapshots in sequence, starting from the snapshot whose number is specified at the time. During the demonstration, the buttons on the pattern/numeric keypad light in turn in the clockwise direction.

•The HOLD INPUT button setting also applies to the demonstration.

•During the demonstration, the control panel does not accept any operations other than pressing the AUTO TRANS button.

To end the demonstration

Press the AUTO TRANS button once more.

Operations Advanced 4 Chapter

Chapter 4 Advanced Operations 4-23