3 Select the downstream key fill signal.
1)Press the PAGE button, and switch to page 1 of the downstream key menu.
DSK | Clip | Gain | INVERT | FILL | Densty |
|
|
|
|
|
|
1/2 | OFF | VIDEO | |||
PAGE | F1 | F2 | F3 | F4 | F5 |
2)Press the F4(FILL) button, to select the signal used as the key fill signal.
VIDEO: Use the signal specified as “DSK FILL” in the delegation section. When you select this, press the DSK FILL button in the delegation section, turning it on, then select the desired bus with the AUXILIARY buttons.
DSKMAT: Use an internal DSK matte signal.
NONE: Do not use a key fill signal (applying the border only).
Note
When you select “NONE”, DSK border automatically goes on. If you now forcibly turn the DSK border off, the downstream key will not appear.
4 Set the downstream key transition time (the time taken to insert the key).
For an instantaneous insert, set the transition time to zero.
For details of the setting, see the section “Setting the Transition Time” (page
5 Press the DSK button to insert the downstream key.
When the downstream key has been inserted, the DSK button lights red.
During the transition, the DSK button lights amber.
Note
Downstream keys are always delayed by 6H.
Deleting the downstream key
When the DSK button is lit red, press it, turning it off.
Adjusting the outline of the downstream key
If the outline of the inserted text or graphics is not sharp, in page 1 of the downstream key menu, adjust the F1(Clip) and F2(Gain) knobs as follows.
•To adjust the degree to which the key is cut out, turn the F1(Clip) knob to adjust the clip level.
•To adjust the sharpness of outline of the key, turn the F2(Gain) knob to
adjust the key gain.
Operation Basic 3 Chapter
Chapter 3 Basic Operation