2Primary
BACKGROUND
1 BACKGROUND bus buttons | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | MEMORY | INT | |
BLACK | VIDEO | ||||||||||
|
|
|
|
|
|
|
|
|
| ||
FOREGROUND |
|
|
|
|
|
|
|
|
| ||
2 FOREGROUND bus buttons | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | MEMORY | INT | |
BLACK | |||||||||||
VIDEO | |||||||||||
|
|
|
|
|
|
|
|
|
| ||
1 BACKGROUND bus buttons | 2 FOREGROUND bus buttons |
Location 2 Chapter Parts
Select the image to form the background for an effect. Select from the following buttons.
BLACK button: Select the black burst signal generated by the internal synchronizing signal generator in this unit.
Buttons 1 to 8: Signals input to the VIDEO INPUT 1 to 8 connectors on the rear panel of the processor unit. Press a button, turning it on, to select the corresponding signal.
You can set the assignment of buttons to input connectors in the setup menu.
MEMORY button: Select the signal recorded in frame memory.
INT (internal) VIDEO button: Select the internal video signal selected by pressing the MATTES button in the menu control section. If you hold down this button and press the DOWN and UP buttons in the pattern/numeric keypad, the selected video signal pattern changes.
When the signal on the background bus is output from the PGM OUT connector on the rear panel of the processor unit, the button which has been pressed lights red.
Select the image to form the foreground for an effect (or the “new” video in a transition).
The functions of the buttons are the same as in the BACKGROUND bus buttons.
When the signal on the foreground bus is output from the PGM OUT connector on the rear panel of the processor unit, the button which has been pressed lights red. If the signal is not output, the button pressed lights amber.
of Function and Controls and
Chapter 2 Location and Function of Parts and Controls |