Editing From Control 5 Chapter Units Control

Control From the BVE-900/2000 Series

You can combine the DFS-700/700P with a BVE-900/910 or BVE-2000 Series Editing Control Unit to carry out A/B roll editing using two players and one recorder.

For details of preread editing, see the section “Preread Editing” (page 5-14).

Connectable editing control units

To control the DFS-700/700P, the BVE-900/910/2000 and optional BKE- 913 board (for BVE-900/910) must have the following ROM versions or higher.

BVE-900

Ver. 1.11 or later

BVE-900 with BKE-900K

Ver. 2.01 or later

BVE-910

Ver. 1.02 or later

BKE-913

Ver. 1.06 or later

BVE-2000

Ver. 1.10 or later

Control using editor control signals

You can control the following DFS-700/700P functions using 9-pin serial control signals from the BVE-900/910/2000. Input these signals to the EDITOR connector on the rear panel of the DFS-700/700P. The functions marked with an asterisk below can only be controlled from the BKE-900 after installation of the optional BKE-900K board.)

•Background image (FROM source) and foreground image (TO source) selection

•Pattern number selection

•Transition direction (normal or reverse) selection

•Transition duration selection

•Automatic transition execution

•Downstream key on and off

•Snapshot saving and recall*

•Saving and loading DFS-700/700P data (snapshots and user program effects)*

Notes

•It is not possible to load and save user program effects or snapshots from the BVE-900/910.

•KEY FADE IN and KEY FADE OUT cannot be used. Also, KEY WIPE OUT and KEY MIX OUT can only be used with versions 2.24 and later of the BVE-2000.

When using KEY WIPE OUT, the effect must be executed in the reverse direction.

5-8Chapter 5 Control From Editing Control Units