Control Panel
4HOLD INPUT button
To hold the primary cross-point bus settings and the auxiliary bus settings (signal selections) fixed when recalling a snapshot, press this button. When you press this button, it lights, and when you recall a snapshot, the system is in the hold input mode. When you recall a snapshot in this mode, all settings are recreated on the control panel except those relating to the primary cross-point bus and the auxiliary bus.
Press the button once more to turn it off and exit the hold input mode.
qa Location section
2 Joystick
3 Z-knob
LOCATION
1LOCATION button
1LOCATION button
Press this button to use the joystick and Z-knob. When you press this button, it lights, and enables the joystick and Z-knob.
Press the button once more to disable the joystick and Z-knob, and return the effect pattern to its default position.
Holding down the INITIAL button while pressing this button returns the setting to its default value.
2Joystick
Use the joystick to position the effect pattern in the x- and y-directions.
3Z-knob
Turn the Z-knob to move an effect pattern in the depth direction (the z-axis). With this you can change the effective size of the pattern.
qs 25-pin connector (rear panel)
Use the supplied 25-pin control cable to connect this to the PANEL connector on the processor unit.
