Sony MAV-555SS Basic Operations with DTR+Panel and DTR+DTR Modes, EE Signal Selection

1 While holding the SHIFT key on the Control Panel, press B1 (Unload).

2 Turn the MULTI CONTROL knob to select the next material to play, and press B1 (Load).

Note

Depending on the settings for the Control Panel, Step 1 may not be necessary.

Please refer to the BKMA-505 Control Panel Operating Manual for details.

Note

Combinations of ports that can be used with EE operation are as indicated by the circles in the table below.

		Playback port
		P1	P2	P3
	R1	O	O	O
Recording port	R2	O	O
	R3	O

5-3-3 EE Signal Selection

In panel mode, when EE signal output has been specified for each playback port, it is possible to specify the recording port for which the EE value is to be output.

In order to make this specification, hold down the PORT SELECT button that corresponds to the target playback port, and then press the PORT SELECT button for the recording port for which the EE value is to be output.

•While the PORT SELECT button for a recording port is pressed, that EE signal is output. When the PORT SELECT button for that recording port is released, the output returns to the PB picture.

•Subsequently, if the EE picture output specification is made for this playback port, the input signal for the recording port that was specified by the initial operation is output as the EE picture.

(Operation Example)

Outputting the R2 port signal when the EE specification is made for the P1 port:

1 While holding down the P1 key, press the R2 key. While the R2 key is held down, the R2 input signal is output to P1.

2 Press the R2 key.

The display returns to the P1 PB picture. Subsequently, if the EE specification is made for the P1 port, the input signal for the R2 port is output as the P1 EE signal.

Note

In Expansion menu item REFERENCE SELECT (menus 349 to 351), when the recording port standard signal is set to “input video”, the EE picture is not output.

For details about the setup menu, refer to Section 3-4, “Setup” (page 3-18).

Chapter 5 Basic Functions of

5-4 Basic Operations with DTR+Panel and DTR+DTR Modes

Each Mode

In DTR+Panel mode, the R1 and P1 ports are controlled through the DTR-3000, while the other ports are controlled through the control panel or an external device. In DTR+DTR mode, R1/P1 and R2/P2 are each controlled separately through two DTR-3000s.

5-4-1 Initial Setup for DTR+Panel and DTR+DTR Modes

Before using the DTR+Panel and DTR+DTR modes, confirm and set up the following:

(1)The DTR-3000 version connected to this unit must be CP:V01.30, VS:V01.20 or later.

(2)The DTR-3000 must be set to the DISK:INDIVIDUAL mode.

(3)The DTR-3000 recording time should be set on this unit.

(4)Whether or not loop recording is used, it should be set on this unit.

(5)Whether or not partial save is performed should be set on this unit.

Please contact your supplier or Sony representative if you require more details about (1) and (2) above.

For more details on (3) and (4) above, please refer to the following operating information.

Setting the Recording Time from the DTR- 3000

1 Set DTR-1 (and DTR-2) in LIVE DURATION (menu 034) on the basic menu to the desired time.

5-4 Basic Operations with DTR+Panel and DTR+DTR Modes 5-3 (E)