access to the disc is completed before the unit switches to the standby state.
Note
While the ACCESS indicator is lit, do not turn off the POWER switch on the rear panel or disconnect the power cord. This could lead to a loss of data from the disc.
cRemote control switch
Different positions of the switch allow different operations as follows.
NET: Enables access to the network. The indicator lights when an external network device is being accessed. In this state, operation from the front panel is not possible.
LOCAL: Enables operation from the front panel.
REMOTE: Enables remote control of this unit from the following devices:
•Devices connected to the REMOTE(9P) connector on the rear panel
•Devices connected to the HDSDI INPUT connector with SDI remote control functions
Use setup menu item 214 REMOTE INTERFACE to select which of the connectors is used for remote control (see page 98).
See “Setup Menu” on page 90 for more information about how to make extended menu settings.
dKEY INHI switch
This turns key operation inhibit mode on or off. Use setup menu item 118 KEY INHIBIT SWITCH EFFECTIVE AREA to specify the keys to inhibit.
ePHONES jack
The jack is a standard stereo jack. Connect stereo headphones to monitor the audio during recording, playback, and editing.
fLEVEL (volume) adjustment knob
Adjust the volume of headphones or speakers with the knob. You can also cause this to simultaneously adjust the output volume from the AUDIO MONITOR R, L connectors on the rear panel. To do this, set setup menu item 114 AUDIO MONITOR OUTPUT LEVEL to “var”.
gDisc slot and EJECT button
Insert a disc in the disc slot. To remove the disc, press the EJECT button.
1 Audio level adjustment section
1
| ALL CH |
| |
| |||
| VARIABLE | KEY INHI | |
NET | REC | ON | |
PRE- | |||
LOCAL | SET | OFF | |
REMOTE | |||
PB | |||
|
|
2VARIABLE switch
a
adjustment knobs
Depending on the setting of the VARIABLE switch, these adjust the input audio or playback audio levels of channels 1 to 4.
By the setting of setup menu item 131 AUDIO VOLUME, you can enable the
bVARIABLE (audio level adjustment selector) switch
This selects which of the input audio and playback audio has the level adjusted by the
REC: Adjust the input audio levels. The playback audio levels are fixed at their preset values.
PRESET: The audio levels are fixed at their preset values.
PB: Adjust the playback audio levels. The input audio levels are fixed at their preset values.
2Arrow buttons
The four arrow buttons are also used as the MARK1 button, MARK2 button, IN button, and OUT button. The correspondence with these buttons is as follows.
Vbutton: MARK1 button v button: MARK2 button B button: IN button
b button: OUT button
You can use these buttons for thumbnail selection, menu setting operations, setting In/Out points, and so on.
1 V/MARK1 button and v/MARK2 button
2IN indicator and OUT indicator
MARK1
INOUT
3 B/IN button and b/OUT button
MARK2
L/JOG
Parts of Functions and Names 2 Chapter
Front Panel 13