To cancel the clip salvage
Press the RESET/RETURN button.
Notes
•The message “EJECT?” appears when “REC INHI” is displayed. If the disc is write protected, eject the disc, set the Write Inhibit tab to enable recording, and then insert the disc again. If REC INH on HOME page of the function menu is set to “ON”, set it to “OFF” (see page 40).
•This operation cannot be cancelled once it begins.
2 Press the PUSH SET(S.SEL) knob.
Processing begins and the message “Executing.” appears.
When processing finishes, a message appears to display the results.
If the message reads “Incomplete!”, the clips that failed were lost.
Playback
This section describes playback of video and audio on the unit.
Before starting playback, make the following settings and adjustments.
Selection of time data to display: Select with CNTR SEL on HOME page of the function menu.
Selection of audio channels to monitor: Select with MONITR L and MONITR R on page P2 AUDIO of the function menu.
Volume adjustment of the monitor audio: Adjust with the LEVEL knob.
Remote/local setting: Set the remote control switch. If you set it to REMOTE, also set setup menu item 214 REMOTE INTERFACE
Disc playback start position
Although this unit uses optical discs, it is designed to offer the most convenient features of tape playback by VTRs. One of these is the playback start position, which works in the same way as tape, as described below.
After playback stop
The unit stops at the position where the STOP button was pressed.
Press the PLAY button to resume playback at the stop position.
After recording
The unit stops at the position where recording ended.
To play back a clip, press the PREV button to move to the start frame of any clip or press the PREV button with the PLAY button held down to move to any position.
After disc insertion
The unit stops at the position of the disc when it was most recently ejected.
Press the PLAY button to resume playback at the most recent position.
The playback position is saved to the disc when the disc is ejected, which allows playback to start at that position whenever it is loaded into any XDCAM player.
Note
This function is not available when the Write Inhibit tab of the disc is set to the recording disabled position, and when REC INH on HOME page of the function menu is set to “ON”.
The REC INHI indicator may light when neither of the above is true if the format of recorded sections on the disc
Playback and Recording 4 Chapter
Playback 47