The buzzer volume is set.

5 Press CLEAR button.

The first screen of the RCP configuration menu reappears.

2Press ENTER button to enable configuration. The cursor appears as “?” and the setting flashes.

3Press ENTER button again to save the settings.

To change the security mode

The RCP-920/921 has an Engineer mode to limit access to certain settings. These settings cannot be configured unless Engineer mode is enabled.

1 Move the cursor to SETTING in the RCP configuration menu, and press ENTER button.

The settings and adjustment screens appear.

2 Use the v and V buttons to move through the settings and adjustment screens, and display the <SECURITY MODE> page.

3 Turn the right adjustment knob to move the cursor to MODE.

4 Change the security mode setting.

1Press ENTER button to enable configuration. The cursor appears as “?” and the setting flashes.

2Turn the right adjustment knob to change the setting to ENGINEER, and press ENTER button.

The security mode setting is changed.

5 Save the security mode setting.

1Turn the right adjustment knob to move the cursor to SET.

6 Press CLEAR button.

The first screen of the RCP configuration menu reappears.

Note

The security mode returns to NORMAL when the unit is turned off.

To change switch assignments

You can change the functions of certain switches on the RCP-920/921 (the camera/CCU function ON/OFF buttons), and assign them different functions.

Note

This setting can only be configured in Engineer mode.

1 Move the cursor to SETTING in the RCP configuration menu, and press ENTER button.

The settings and adjustment screens appear.

2 Use the v and V buttons to move through the settings and adjustment screens, and display the <SW ASSIGN> page.

Note

The LCD can only display up to four setting items at one time. If a page has more than four items, turn the right adjustment knob to scroll the page.

3 Turn the right adjustment knob to move the cursor to the switch you want to configure.

Note

When you enter the settings configuration mode, the LEDs for all of the assignable switches dim temporarily, and only the switch selected for configuration with the cursor will remain lit. This allows you to confirm the switch for which you are currently changing the function.

Initial Settings 69