2 Use the v and V buttons to move through the settings and adjustment screens, and display the <ETHERNET IF> page.
Note
The LCD can only display up to four setting items at one time. If a page has more than four items, turn the right adjustment knob to scroll the page.
¯
3 Enable or disable Ethernet interface.
When using Ethernet, enable Ethernet interface. (Factory setting: OFF)
1Turn the right adjustment knob to move the cursor to ETHERNET.
2Press ENTER button to enable configuration. The cursor appears as “?” and the setting flashes.
3Turn the right adjustment knob to change the setting, and press ENTER button.
¯
The Ethernet interface setting is configured.
¯
4 Configure each Ethernet interface setting.
The items you can configure are as follows. AUTO NEGO: The Ethernet interface of this unit
supports Auto Negotiation. If the devices to which you are connecting support Auto Negotiation, set this to ON and the transmission rate (Speed) and transmission method (Duplex) will be set automatically. If the devices do not support Auto Negotiation, set this to OFF.
(Factory setting: ON)
AUTO MDIX: Automatically set the polarity of the Ethernet cable to be connected. If Auto Negotiation is enabled, you can set this to ON. (Factory setting: ON)
SPEED: This is the connection speed setting for the
Ethernet line. If Auto Negotiation is disabled, manually configure this setting (10M or 100M) based on the devices to be connected.
(Factory setting: 100M)
DUPLEX: This is the transmission method setting for the Ethernet line. If Auto Negotiation is disabled, manually configure this setting (HALF or FULL) based on the devices to be connected.
(Factory setting: FULL)
MDI/MDIX: Set the polarity of the Ethernet cable to be connected. If AUTO MDIX is disabled, manually set the polarity (MDI or MDIX) based on the devices and cable to be connected.
(Factory setting: MDI)
1Turn the right adjustment knob to move the cursor to the item you want to configure.
2Press ENTER button to enable configuration. The cursor appears as “?” and the setting flashes.
3Turn the right adjustment knob to change the setting, and press ENTER button.
¯
The Ethernet interface settings are configured.
¯
5 Save the Ethernet interface settings.
1Turn the right adjustment knob to move the cursor to SET in the upper right of the screen.
2Press ENTER button to enable configuration. The cursor appears as “?.”
3Press ENTER button again to save the settings.
6 Press CLEAR button.
The first screen of the RCP configuration menu reappears.
Initial Settings 75