3 Turn the right adjustment knob to move the cursor to the item you want to change.

4 Change the sensitivity for each adjustment knob.

1Press ENTER button to enable configuration. The cursor appears as “?” and the setting flashes.

2Turn the right adjustment knob to change the setting, and press ENTER button.

¯

¯

¯

The sensitivity is changed.

¯

¯

¯

5 Press CLEAR button.

The first screen of the RCP configuration menu reappears.

To configure system connection settings

The RCP-920/921 supports system connections via the CCU/CNU REMOTE connector and connections to camera network systems via the Ethernet connector. Perform the following steps to configure system connection settings.

Notes

•To apply the configurations, you must restart the unit.

•This setting can only be configured in Engineer mode.

1 Move the cursor to SETTING in the RCP configuration menu, and press ENTER button.

The settings and adjustment screens appear.

2 Use the v and V buttons to move through the settings and adjustment screens, and display the <CNS SETTING> page.

Note

The LCD can only display up to four setting items at one time. If a page has more than four items, turn the right adjustment knob to scroll the page.

3 Select a system connection mode.

The following three modes are available. Select one based on your system environment.

LEGACY: Select this mode when using the CCU/ CNU REMOTE connector and a CCA-5 cable for system connection.

BRIDGE: Select this mode when using Ethernet to connect the RCP to a CCU or camera on a one-toone basis.

MCS: Select this mode when using Ethernet to connect to a multi-camera system (MCS) comprised of multiple cameras, CCUs, and panels.

(Factory setting: LEGACY)

Notes

•For details on selecting your mode, see one of the sections that follow: “To configure Legacy mode,” “To configure Bridge mode,” or “To configure multi-camera system (MCS) mode.”

•When using an Ethernet connection, be sure to configure the Ethernet connection settings.

4 Save the system connection settings.

1Turn the right adjustment knob to move the cursor to SET in the upper right of the screen.

2Press ENTER button to enable configuration. The cursor appears as “?.”

3Press ENTER button again to save the settings.

5 Press CLEAR button.

The first screen of the RCP configuration menu reappears.

To configure Legacy mode

1 Set the camera network system mode (CNS MODE) to Legacy.

1Turn the right adjustment knob to move the cursor to CNS MODE.

2Press ENTER button to enable configuration. The cursor appears as “?” and the setting flashes.

Initial Settings 71