3Turn the right adjustment knob to select LEGACY, and press ENTER button.
The CNS mode is set.
The CNS mode is set.
2 Save the system connection settings.
1Turn the right adjustment knob to move the cursor to SET in the upper right of the screen.
2Press ENTER button to enable configuration. The cursor appears as “?.”
3Press ENTER button again to save the settings.
3 Press CLEAR button.
The first screen of the RCP configuration menu reappears.
To configure Bridge modeBridge mode connects the RCP to the CCU on a
1 Set the camera network system mode (CNS MODE) to Bridge.
1Turn the right adjustment knob to move the cursor to CNS MODE.
2Press ENTER button to enable configuration. The cursor appears as “?” and the setting flashes.
3Turn the right adjustment knob to select BRIDGE, and press ENTER button.
2 Set the submode for Bridge mode.
In Bridge mode, you must configure the submode and target IP address to determine functioning. Under normal circumstances, set the RCP to ACTIVE or
1Turn the right adjustment knob to move the cursor to CONNECT.
2Press ENTER to enable configuration.
The cursor appears as “?” and the setting flashes.
3Turn the right adjustment knob to change the setting item.
Select one of the following based on the connection status.
ACTIVE: Connects to the target automatically.
PASSIVE: Awaits connection from the target.
(Factory setting:
Note
If both devices in the connection are set to Active, malfunctions may occur.
3 Set the target IP address.
1Turn the right adjustment knob to move the cursor to TARGET IP ADDRESS.
Enter the IP address of the target device for connection when Active or
2Press ENTER button to enable configuration. The cursor appears as “?” and the first section of the IP address flashes.
72 Initial Settings