Adjusting the LCD

Display

The RCP-920/921 is provided with LCD-display adjustment mode, which permits you to adjust the brightness and contrast of the LCD display of the paint control block.

To enter LCD-display adjustment mode

While holding down the PARA and MASTER buttons, press the ENTER button on the paint control block. The LCD display shows the following:

To adjust the LCD display

Turn the paint controls (rotary encoders). You can adjust the brightness with the left control and the contrast with the right control.

To release LCD-display adjustment mode

Press the PARA and MASTER buttons simultaneously. The menu display before entering the LCD-display adjustment mode reappears.

Note

The values set in LCD-display adjustment mode are stored in memory when the modes are canceled. Be sure to release the modes before turning OFF the power.

Specifications

General

 

Power requirements

10.5 to 30 V DC

Power consumption

4 W max.

Maximum cable length

200m (656 ft) (with CCA-5 cable connection)

Operating temperature

5 °C to 40 °C (41 °F to 104 °F)

Dimensions (w/h/d, excluding projections) RCP-920/921: 102 × 310 × 67 mm (4 1/8 × 12 1/4 × 2 3/4 in)

Dimensions (w/h/d, including projections)

 

RCP-920: 102×310×125 mm

 

(4 1/8 × 12 1/4 × 5 in)

 

RCP-921: 102 × 310 × 84 mm

 

(4 1/8 × 12 1/4 × 3 3/8 in)

Mass

1.8 kg (3 lb 15 oz)

Inputs/outputs

 

REMOTE

 

 

8-pin RJ-45 connector

CCU/CNU

8-pin multiconnector, female (1)

AUX

8-pin multiconnector, female (1)

EXT I/O

10-pin, male (1)

Supplied accessories

Operation Manual (1)

Optional accessories

External I/O connector

HIROSE HR10A-10PA-10S (74) 1-566-437-12

CCA-5-3 remote cable (3 m) CCA-5-10 remote cable (10 m) CCA-5-30 remote cable (30 m)

Design and specifications are subject to change without notice.

Note

Always verify that the unit is operating properly before use. SONY WILL NOT BE LIABLE FOR DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO, COMPENSATION OR REIMBURSEMENT ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS DUE TO FAILURE OF THIS UNIT, EITHER DURING THE WARRANTY PERIOD OR AFTER EXPIRATION OF THE WARRANTY, OR FOR ANY OTHER REASON WHATSOEVER.

76 Adjusting the LCD Display / Specifications