Setting the Code for Preset Audio and Visual Components (continued)

5Press the four-digit component code number followed by the ENTER key on the touch-key display.

Example: To enter “8056”

Input “8,” “0,” “5,” “6,” and press “ENTER”.

If you press the CLEAR key during inputting the digits

Input digits are canceled. The four- digit component code number previously set is displayed, and the cursor returns to the first digit.

When the setting of the code succeeded

The selected component name, the preset four-digit component code number and “OK” light while a beep sounds. And the display returns to Step 3.

6If you want to set a code for another component, repeat Steps 4 and 5.

7Press COMMANDER OFF.

COMMANDER

OFF

If you keep COMMANDER OFF pressed for more than 2 seconds

The Commander turns off.

If you keep COMMANDER OFF pressed for less than 2 seconds

The Commander returns to the previous setting mode.

Notes

•If you press a component code number that is not on the table in the supplied “Component Code Numbers”, the Commander beeps five times and “NG” flashes after you press the ENTER key. The setting returns to the previous one. If this happens, check the component code number, and try setting again.

•If you don’t input anything into the Commander for over two minutes between each step, the setup procedure will be canceled. To set the code, you must again press MUTING while pressing

COMMANDER OFF.

•The first digit of the component code number means the component category (TV, VCR, etc.). The component corresponding to the four-digit component code number is preset in Step 5. If you preset the component of which category is different from that preset previously to the Component Select button or the Label key, you can, if necessary, change the component names on the Mode Display key or the Label keys (see page 79).

•If you preset a component code after you input character contents to the Mode Display key (page 24) or the Label keys (page 23), they are cleared and return to the original display. Edit the characters after you decide the component to be used by presetting a code.

14