To program a new series of operations for the buttons which have already been set
SYSTEM CONTROL 1 or 3 button:
Erase the factory preset program. See page 37.
Other buttons:
Erase the program. See page 35.
4Select the component to operate by pressing the Component Select button (in this case, TV) or the Label key.
To change label keys, press the OTHER button repeatedly until you obtain the desired component name.
TV
The selected component name is displayed on the Mode Display key, and the keys for the selected component flash.
5Press the key(s) or button(s) for the desired operation.
If you want to turn on the TV, press the POWER key.
6Repeat Steps 4 and 5 and program the buttons and keys for the series of operations.
In this example, press the following buttons and keys.
7When you have programmed all the keys and buttons, press
COMMANDER OFF.
COMMANDER
OFF
With a beep sound, a series of operating commands is registered and displayed in order. When the display of keys for the component of which key you programmed last appears, the System Control setting finishes.
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
When you have programmed the buttons on the Commander
The names of buttons on the Commander which are not on the LCD touch key display (VOLUME +/ 
, 
, 
, and 
) are displayed on the right Label key.
Continued 33