5Press and hold down the button of the remote control until you hear a beep.
(If you release the button before you hear a beep, the signal may not be learned correctly.)
While receiving the signal, “LEARN” stays lit.
If “NG” flashes on the display and “NG” sound is heard five times
Learning did not succeed. Try Steps 4 and 5 again.
6Press COMMANDER OFF.
COMMANDER
OFF
Note
You cannot program a remote control signal for a SYSTEM CONTROL button or a Label key by “learning” for which the System Control function have been programmed. If you want to program a remote control signal for that button, clear programmed commands first (page 35).
To clear the learned remote control signal
1While pressing COMMANDER OFF, press MUTING.
2Press the LEARN key.
“LEARN” appears on the Mode Display key.
3While pressing the DEL key, press the SYSTEM CONTROL button or the Label key of which learned signals are to be cleared.
The learned signals are cleared.
4Press COMMANDER OFF.
If you want to program a new signal for that button, follow Steps 4 to 6 in the left column.
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previous setting mode.
Continued 51