Setting the Timer (continued)
4When the program number of which contents you want to change appears on the left Label key, press that Label key.
With a beep sound, the contents of selected program is copied to the program number on the Mode Display key (in this case, PROG4). The day of the week and the time for the copied timer program are displayed on the Clock Display key. “ON/OFF,” “TEST,” “SETUP,” and “COPY” flash on the Label keys.
5Press the SETUP key.
“DAY,” “TIME,” and “MACRO” flash.
6Press the key of which contents you want to change.
DAY: See Step 5 on page 62.
TIME: See Step 6 on page 63.
MACRO: The display turns as below.
7Press the OK key.
With a beep sound, the Timer Macro setting is cleared, and the Commander enters the Timer Macro setting mode (Step 7 on page 63).
If you press the NG key
The display returns to Step 5.
Note
You cannot change the Timer Macro setting partially. If you want to change the program without clearing the frequently used procedure, use the System Control function (page 31). For example, if Steps A to D are frequently used when you want to program Steps A, B, C, D and E, program Steps A to D using the system macro. Then program Step E in the Timer Macro adding to that system macro.
66