For accurate learning
•Do not move the remote units during the learning procedure.
•Be sure to keep holding down the button of the other remote control until you hear the confirmation beep.
•Use fresh batteries in both remote control units.
•Avoid learning in places under direct sunlight or strong fluorescent light.
•The remote control detector area may differ depending on each remote unit. If learning does not work, try changing the positions of the two remote control units.
•When you teach signals of an interactive signal exchange system remote control unit (supplied with some of Sony’s receivers and amplifiers) to the Commander, the response signal of the main unit may interfere with the learning of the Commander. In such a case, move to a place where the signals will not reach the main unit (e.g. other rooms, etc.).
Changing or erasing the function of a taught key or button
To change the learned function, clear it first and perform learning again.
To clear the learned function of a single key or button
1After Step 4 (page 20), while pressing the DEL key, press the key or button you want to erase.
The cleared key flashes together with other learnable keys.
2Press COMMANDER OFF.
COMMANDER
OFF
IMPORTANT
Be sure to place the Commander out of the reach of small children or pets. Also set the Hold function to lock the all buttons on the Commander (page
71)when it is not used. Components such as air conditioners, heaters, electric appliances, and electric shutters or curtains receiving an infrared signal can be dangerous if misused.
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previously set mode.
Continued 25