4Press CHANNEL + or CHANNEL – to search component code numbers in the same category (in this case, code numbers which begin with “8”).
Press CHANNEL + to go to the next code number.
Press CHANNEL – to go back to the
previous code number.
CHANNEL
6Press the ENTER key.
A beep sounds, and the selected component name, the preset four- digit component code number and “OK” light for two seconds. And the display returns to Step 2.
Note
It is recommended to write down the code number.
7Press COMMANDER OFF.
COMMANDER
OFF
Note
To search component code numbers in another category, return to Step 3, or input a
5Aim the Commander at the component and press the POWER key.
When the remote control signal is
sent,is shown on the display.
If it successfully works
If it doesn’t, repeat Steps 4 to 5.
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previous set mode.
17