“COMPO X” appears on the Mode Display key, and the selected component name appears on the left Label key.
5Press the “ENTER” key.
During transferring the data, “c c c c” flashes.
When the data has been successfully transferred, “END” appears on the right Label key.
3Press the Component Select button of which data you want to send.
Or press the Label key of which data you want to send. (To change the Label keys, press the OTHER button repeatedly.)
TV
Note
If “NG” appears while sending the data, go back to Step 6 and continue the operation or press COMMANDER OFF to stop the operation.
The component name of which contents are to be transferred appears on the left Label key.
4Confirm that the receiving remote commander is ready to accept data.
(To set the receiving commander, follow the procedure on page 56.)
6Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previous setting mode.
Notes
•The data of the System Control function programmed for a Component Select button cannot be transferred.
•Be sure that the receiving Commander is ready to receive data.
Continued 55