Checking if the code number works
1Press the corresponding Component Select button or the Label key for the component you have set up.
To display and change the Label keys, press the OTHER buttons repeatedly.
TV
The Commander turns on and the
2Turn on the component by its power switch.
3Aim the Commander at the component and press the POWER key in the
When the remote control signal is
sent,is shown on the display.
The component should turn off.
4If you have succeeded, check that the Commander is operating the other functions of your component, such as channel and volume control.
See page 18 for details.
5Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previous setting mode.
If the Commander does not seem to be working
Try repeating these setup procedures using the other codes listed for your components (see page 12).
Notes on keys which have “learned” a remote control signal already
If another signal has already been programmed on that key or button by the learning function (page 19), that “learned” signal will apply even after you set the component code number. To use it as a preset component key or button, first erase its learned signal (page 25).
Continued 15