Transferring Data between Commanders (continued)
7Press the ALL key.
ALL
ALL: All data of the Commander
COMPO: Data of a Component Select button or a Label key
“ALL X” appears on the Mode Display key, and “ALL” appears on the left Label key.
8Confirm that the receiving Commander is ready for data.
(To set the receiving commander, follow the procedure on page 56.)
9Press the “ENTER” key.
During transferring the data, “c c c c c c c c” flashes. When the all data has been successfully transferred, “END” appears on the right Label key.
Note
If “NG” appears while sending the data, go back to Step 5 and continue the operation or press COMMANDER OFF to stop the operation.
10 Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previous setting mode.
Note
Be sure that the receiving Commander is ready to receive data.
To transfer the data of a Component Select button or a Label key
The data of a Component Select button or a Label key on this Commander (the settings and learned signals programmed on the keys and buttons) can be transferred to a Component Select button or key on another Sony
1Follow Steps 1 to 6 on page 53.
2Press the COMPO key.
COMPO
54