To change the program name on the Mode Display key
After Step 3, hold the Mode Display key pressed for more than 2 seconds. The Commander enter the Label Inputting mode.
Then follow the same procedure as that for changing the name of the Label key in Steps 2 - 5 on page 24.
To change the interval between timer operation steps
See page 40.
Notes
•When using the timer setting on this Commander, only one setting can be assigned to one program. If you want to set the timer to turn on at a programmed time, and to set the timer to turn off at another time, program the two settings separately.
•If there are some programs set to be executed at the same time, they start in order from the lowest program number.
•According to the status of the component operated by the timer program, the next program might not function successfully. When setting a timer program, check carefully the setting of other programs.
Changing the program already set or changing another program that you select
1Follow Steps 1 - 3 on page 61, 62.
2Press the COPY key.
If you want to change the program already set, go to Step 6 without pressing the COPY key.
The program number appears on the left Label key, and “COPY” flashes on the right Label key.
3Press the COPY key repeatedly until the program number of which contents you want to change appears. (Each time the COPY key is pressed, the program number which has the timer setting information appears in order.)
Continued 65