To change the Label keys, press the Mode Display key (in this case, VCR) repeatedly. Each time you press the VCR key, the display of the Label keys changes as follows.
VCR
Note on the flashing display
The keys or buttons that are already preset for that component flash twice while those that are not preset flash once.
When teaching on the button that is not on the LCD
Only “LEARN” flashes.
6Press and hold down the button on the other remote control until you hear a beep.
(If you release the button before you hear a beep, the signal may not be learned correctly.)
“LEARN” stops flashing and stays lit. When the command has been learned successfully, the learned keys stay lit and the other learnable keys flash.
If “NG” flashes on the display
Learning did not succeed. Try Steps 5 and 6 again.
To change the name of the Label key
Follow the procedure on page 23.
To change the component name on the Mode Display key
See page 24.
To change the function display of the key
Follow the procedure on page 23.
5Press the key or button on the Commander you want to “teach”.
“LEARN” flashes and the only pressed key remains on the display.
7Repeat Steps 5 and 6 to teach functions to other keys or buttons.
To learn another component’s remote control signal
Select the component in Step 4, and then follow Steps 5 and 6 to perform learning.
8Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previously by set mode.
Continued 21