Sony RM-VZ950T 10GB, This example, To cancel setup, When you set the code number to, Tips

Setting the Component Codes (continued)

Notes

•You cannot set “AMP” at “S-1” to “S-7.” You can set “AMP” only at “S-8.”

•If you press the Jog dial at “EXIT,” the Commander returns to the top of the Component PRESET mode (Step 3).

6Press the Jog dial.

The three-digit code number next to the component name flashes in the display.

S-1

TV ¢￿¢￿1

PRESET

7Press the Number buttons to enter the three-digit component code number.

As you press a button, the number appears from the right side of the flashing numbers, and moves to the left when you press another button.

In this example:

Press 0, 8, 6.

When you set the code number to “000”

The component set at this Setting position number does not appear in the display at normal mode, and you cannot operate the component. This is useful when you want to skip unused components.

To put it back to the display, set the code number to match your component.

Tips

•You can also press PROGR +/– to go to the next/previous code number.

•It is useful that you take a note of the code number.

8Press the Jog dial.

“OK” appears in the display. The code number is set, and the Commander returns to the Component PRESET mode.

S-1

OK

PRESET

S-1

TV

PRESET

If “NG” flashes twice and the three-digit component code number flashes again after you press the Jog dial, it means that the setup is incomplete. Check the component code number, and try setting again from Step 7.

If you want to set a code for another component, repeat from Steps 4 to 8.

9Select “EXIT,” then press the Jog dial to finish setting.

To cancel setup

Press SET.

10GB