Sony RM-VZ950T Vcr, About the LCD display, How to use the Jog dial, Example At normal mode

About the LCD display

The LCD (Liquid Crystal Display) displays the component in operation or the current status of the Commander as shown below. It also has a backlight that lights up when you turn or push the Jog dial during component operations (does not light up at SET modes). When a remote control signal is sent, appears in the display.

Example: At normal mode

Remote control signal indicator

How to use the Jog dial

The Jog dial can be used to perform various operations at the setup procedure, as well as selecting the components to operate.

Example: At normal mode

1Turn the Jog dial to select the component you want to operate.

VCR

Current Component

Example: At SET mode

Remote control signal indicator

Setting position number*

S-1

TV ¢￿¢￿1

PRESET

Component	Component
	code number
Setting mode

*You can control up to 8 components, each of which are preset at Setting position numbers “S-1” to “S-8.”

Note

At normal conditions, the LCD display shows the last selected component name. When the batteries are low of charge, “BATT” appears in the display after you press a control button.

2Press the button for the desired function.

Example: At SET mode

1Turn the Jog dial to select the Setting position number (“S-1” to “S-8”).

2Press to enter.

The component name flashes in the display.

S-1

TV

PRESET

Tip

You can also press b/B instead of turning the Jog dial to the left/right (except for when you select a character at the NAME mode).

You can also press OK instead of pressing the Jog dial.

7GB